Removed the stream example code from the Low Level VirtualSerial demos, as they were buggy and only served to add clutter.

Fix Doxygen configuration files' input file exclusion filters.

Fixed CDC and RNDIS host demos and class drivers - bidirectional endpoints should use two seperate pipes, not one half-duplex pipe.

Added explicit ADC channel masks for the standard set of ADC channels, as the single-ended channel MUX masks are not equal to the channel number on some AVR models. Changed demos to use the new channel masks when using the ADC driver.

Fixed DFU bootloader programming not discarding the correct number of filler bytes from the host when non-aligned programming ranges are specified (thanks to Thomas Bleeker).

Fix up the incomplete Webserver project so that it integrates with the uIP stack correctly. Add simple HTTP webserver as a placeholder until FatFS can be integrated.

Begin to look into the RNDIS Host Class Driver, which seems to crash on test hardware after many packets have been received.

Update library manual with the new XPLAINBridge project's dual mode bridge/programmer functionality.

Fixed a bug in the incomplete Webserver project, where the packet data was not being written to and read from the correct buffer address.

Fixed lack of support for the ATMEGA32U2 in the DFU and CDC class bootloaders

Changed incomplete Webserver project over to using the uIP timer library.

Fixed incorrect interface values in the VirtualSerialMouse and KeyboardMouse demo class driver structures.

Added caveat information to the CDC device class driver.

Added support to the MIDI Class drivers for packed data, where multiple MIDI events are packed into a single USB packet. Added new MIDI Class driver flush routines to override packing behaviour.

Inline USB management functions in the Class drivers which are standardized but currently unused, to prevent them from using up unneccesary cycles and flash in the user application.

Add new TemperatureDataLogger project, a simple USB Mass Storage class Temperature Data Logger using the onboard Dataflash and Temperature sensor.

Fixed AVRISP PDI race condition where the guard time between direction changes could be interpreted as a start bit. Fixed TPI interface lines not being changed correctly when in bit-banged TPI mode.

Added command timeout to the AVRISP project so that incorrectly connected targets no longer freeze the device.

Removed string descriptors from the TeensyHID bootloader to reduce its size.

Fixed USB_CurrentMode not being reset to USB_MODE_NONE when the USB interface is shut down and both Host and Device modes can be used (thanks to Daniel Levy).

Add new HotmailNotifier project, which changes a LED's colour based on the user's unread email count as sent from Windows Live Messenger.

The SImage_Host_SendBlockHeader() and SImage_Host_ReceiveBlockHeader() Still Image Host Class driver functions are now public.

Use default NVM base address in the AVRISP programmer project in case the host programmer software doesn't set it correctly.

Fix a bug in the Still Image Host Class driver where the returned block status code was being truncated.

Add programming support to the AVRISP project's PDI programming mode; paged memory writes are not currently functional.

The AVRISP project can now enter PDI mode under both bit-bang and hardware USART connection modes, tested against the XPLAIN board hardware. Still need to complete higher level NVM access code so that the device's memories can be read and written.

Fix inverted bit-banged USART logic in the AVRISP project for PDI programming. Add a delay to the clock toggling in the AVRISP project to ensure that the programming speed does not exceed 10MHz under any conditions to satisfy the limits in the datasheet for all target voltages. Fix incorrect pin being used as the DATA in in PDI programming mode.

Increase timeout of Mass Storage and Still Image host commands to 10 seconds (up from 5) to account for slow-processing devices.

Added brace guards to macros with parameters to prevent unintended changed evaluation of the macro expression.

Minor code cleanups (remove redundant comments, fix spacing, etc.).

Make sure that USB_STREAM_TIMEOUT_MS is set in the MassStorageHost ClassDriver demo, so that slow devices don't time out the data pipe. Increase pipe timeout in both MassStorageHost demos to 5 seconds to account for the really slow devices.

Fix TeensyHID bootloader not properly shutting down the USB interface to trigger a disconnection on the host before resetting the AVR.