Commit d2df3a8c authored by Sara Falcone's avatar Sara Falcone


parent 64c4961f
......@@ -40,17 +40,15 @@ This is an H-bot machine, with 4 linear rod rails, 6 linear bearings, a linear r
A motivation in the design for this machine was a desire to practice routing on the Zünd. After punturing through holes with the waterjet I put the parts on the Zünd and used the optical registration feature to allign them. I made several of the 1/4" Al parts on th Zünd. Below is an image showing the edge of parts cut on the Zünd (on bottom) and waterjet (middle) and the surface of an Al sheet (top).
![water jet compare](/images/IMG-3157.JPG)
<img src="/images/IMG-3157.JPG" width=50%/>
And this is an angled view of that piece which was routed with a 6mm end mill, then finished with a 2mm to get smaller internal radiuses. It was tapped afterwards.
<img src="/images/IMG-3156.JPG" width=50%/>
![Zund compare](/images/IMG-3156.JPG)
The optical registration didn't proove accurate enough to re-allign parts after they'd been moved. I tried a few times and the second pass was visibly off. For rapidity of fabrication I ended up waterjetting about half of the peices, but the machine came together within the week.
![finished fab](/images/IMG-3087.JPG)
<img src="/images/IMG-3087.JPG" width=50%/>
# Action
Markdown is supported
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment