2.25 KB
Newer Older
Jake Read's avatar
Jake Read committed
1 2 3 4 5 6
# Roller Milling

Spent some time working this out on the whiteboard today, and threw together some rhino sketches.


Jake Read's avatar
Jake Read committed
I'm going for simple, strong-enough, and easy to build. Using rollers and pulleys, or, just as easily, rack and pinion or leadscrew-type actuation.
Jake Read's avatar
Jake Read committed
8 9 10

Next up, getting into fusion to get through the details, then fabbing one axis... designing a simple 3axis machine, and fabbing that.

Jake Read's avatar
Jake Read committed
11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42
I pulled this off with a simple set of flat-milled parts - I was trying to work with the constraints present in the set of FREP and Milling tools in MODS, to see if we could finish end-to-end gantry generation and milling.

The result is OK, it'll certainly do - there's a line to toe between being kinematically wicked and loosing complexity. This is a bit of a midpoint - all of the axis of constraint have 'tuneability' in that their preloads can be adjusted, but all are over-constrained. There's enough (lots) flex in HDPE that this will be OK. There's a version which (not actually existing yet) is dead simple and totally constrained, and a version which is *perfect* motion-wise. 

Overall, it's a bit bulky. There's some detailing left out before it is complete. But I think in terms of an all-arounder axis, this is pretty OK, and certainly OK for being millable from one sheet of HDPE (or alu, whatever).

## CAD

Available Here: 

password is *rollercoaster*

The gantry is built with a set of 'kinematic elements' - a Motor / Pulley Unit, Lateral (into the gantry) and Cross (across the gantry) supports:


These can be jimmied around to make a full set of constraints:

![more bits](/images/multiple-bits.png)

And combined into a complete gantry:


Here's the back of that:


## Hardware Notes

Motor Idlers / Topside Way Bearings mount on M5 SHCS with washers on *both sides* and washers used as bearing shims. Use 3DP bushing (or purchased?) in axel. Important for carrying some moment to plate.

Jake Read's avatar
Jake Read committed
43 44 45 46 47 48 49
Clearances here for pulley to be mounted / tensioned! Consider order of assembly, tensioning.

M5 Nuts 93625A200
M5 SHCS (length not selected) 91292A128
M5 Washers 93475A240

also uses long M3's for tuning, nuts, washers. Length to be selected.