Skip to content
Snippets Groups Projects
Select Git revision
  • master
1 result

simplespindle

  • Name Last commit Last update
    cad
    log
    .gitignore
    README.md

    The ER-Holder Simple Spindle

    log

    This is a simple spindle for simple milling machines, that we can make with a 3D Printer and some off-the-shelf parts.

    It uses a 'collet holder' (which can be found on ebay) with two simple roller bearings on either end to form the main mechanism. See! Simple. Drive that with a BLDC motor, and you're milling.

    spindle

    Notes

    The belleville washers (disk springs) included in the BOM should be mounted between the collet-holder collet-holding end and the inner race of the bottom bearing. The 40T pulley w/ respective set-screws holds the collet holder into the bearing / body assembly - as you tighten those screws, try to compress those belleville washers. This way the bearings are a little bit preloaded, which helps them run smooth / for a long time / quitely. S/O to Ilan Moyer for this tip.

    Runout

    I measured a runout at the collet holder of ~ 1 thousandths, and at the tip of a 1/8" tool around ~ 3 thousandths. That's OK for $150 in parts, and a plastic housing.

    spindle test

    BOM

    This is a short list of parts for the latest design as of 2020 07 10 as implemented on clank.

    What Spec QTY
    Collet Holder C8 ER11 100L 1
    Skate Bearings 608ZZ or 5972K501 2
    Belleville Washers 96475K331 2
    Shaft Coupling 5mm Side 9845T105 1
    Shaft Coupling 8mm Side 9845T108 1
    Shaft Coupling Guibo 9845T110 1
    FHCS M3x10 4
    FHCS M4x40 4
    M4 Locknuts 4
    Motor NTM 35-36 1