Fixed lack of support for the ATMEGA32U2 in the DFU and CDC class bootloaders

Changed incomplete Webserver project over to using the uIP timer library.

Fixed incorrect interface values in the VirtualSerialMouse and KeyboardMouse demo class driver structures.

Added caveat information to the CDC device class driver.

Added support to the MIDI Class drivers for packed data, where multiple MIDI events are packed into a single USB packet. Added new MIDI Class driver flush routines to override packing behaviour.

Inline USB management functions in the Class drivers which are standardized but currently unused, to prevent them from using up unneccesary cycles and flash in the user application.

Fix MassStorageKeyboard demo USE_INTERNAL_SERIAL check being performed before the required library headers were included, causing a compilation error.

Added notes to the class driver functions indicating which functions require what Device/Host state machine states to function.

Add new TemperatureDataLogger project, a simple USB Mass Storage class Temperature Data Logger using the onboard Dataflash and Temperature sensor.

Fixed AVRISP PDI race condition where the guard time between direction changes could be interpreted as a start bit. Fixed TPI interface lines not being changed correctly when in bit-banged TPI mode.

Added command timeout to the AVRISP project so that incorrectly connected targets no longer freeze the device.

Removed string descriptors from the TeensyHID bootloader to reduce its size.

Combine AVRISP project TPI and PDI lib directories - these protocols use the same underlying XPROG wrapper for the host-to-programmer command wrapping.

Enhance the HotmailNotifier project so that the LEDs' individual brightness can be controlled individually via software PWM.

Fixed USB_CurrentMode not being reset to USB_MODE_NONE when the USB interface is shut down and both Host and Device modes can be used (thanks to Daniel Levy).

Add new HotmailNotifier project, which changes a LED's colour based on the user's unread email count as sent from Windows Live Messenger.

The SImage_Host_SendBlockHeader() and SImage_Host_ReceiveBlockHeader() Still Image Host Class driver functions are now public.

Use default NVM base address in the AVRISP programmer project in case the host programmer software doesn't set it correctly.

Complete initial working revision of PDI programming in the AVRISP project (XMEGAs can now be programmed by the firmware).

Fix a bug in the Still Image Host Class driver where the returned block status code was being truncated.

Add programming support to the AVRISP project's PDI programming mode; paged memory writes are not currently functional.

The AVRISP project can now enter PDI mode under both bit-bang and hardware USART connection modes, tested against the XPLAIN board hardware. Still need to complete higher level NVM access code so that the device's memories can be read and written.

Fix inverted bit-banged USART logic in the AVRISP project for PDI programming. Add a delay to the clock toggling in the AVRISP project to ensure that the programming speed does not exceed 10MHz under any conditions to satisfy the limits in the datasheet for all target voltages. Fix incorrect pin being used as the DATA in in PDI programming mode.

Increase timeout of Mass Storage and Still Image host commands to 10 seconds (up from 5) to account for slow-processing devices.

Added brace guards to macros with parameters to prevent unintended changed evaluation of the macro expression.

Minor code cleanups (remove redundant comments, fix spacing, etc.).

Make sure that USB_STREAM_TIMEOUT_MS is set in the MassStorageHost ClassDriver demo, so that slow devices don't time out the data pipe. Increase pipe timeout in both MassStorageHost demos to 5 seconds to account for the really slow devices.

Fix TeensyHID bootloader not properly shutting down the USB interface to trigger a disconnection on the host before resetting the AVR.