Oops - new Write Word alignment code in the TPI programming function means that the WriteBuffer parameter is no longer const.

Fixed incorrect values of USB_CONFIG_ATTR_SELFPOWERED and USB_CONFIG_ATTR_REMOTEWAKEUP tokens (thanks to Claus Christensen).

Mark the AVRISP-MKII project descriptors as being both Bus Powered and Device Powered.

Copy over file level documentation of the peripheral drivers to the module level documentation.

Use _delay_us() function in the XPROGTarget.c file to ensure timing requirements are met, rather than a fixed number of NOPs.

Oops - PDI handshake delay was too long, causing the device's /RESET functionality to be re-enabled.

Oops - TPI programming is broken in the AVRISP project because the busy-flag check wasn't inverting the result.

Clean up Webserver project - add more Doxygen documentation for the new DHCP client functions and defines.

Ensure TPI enable timing requirements are met in AVRISP-MKII programmer. Remove invalid code in the TPI read/write functions.

Manually pull PDI clock pin high for 1ms before disabling PDI mode in the AVRISP-MKII project, to ensure that the PDI bus is disabled in the target and /RESET functionality restored.

Fix Doxygen configuration files' input file exclusion filters.

Minor code cleanups, remove TemperatureDataLogger host application's Visual Studio Solution files, add LibHIDNet license files.

Added explicit ADC channel masks for the standard set of ADC channels, as the single-ended channel MUX masks are not equal to the channel number on some AVR models. Changed demos to use the new channel masks when using the ADC driver.

Enhance TemperatureDatalogger project -- add RTC capabilities so that data is logged along with the current time and date. Make logging interval configurable, set by a C# PC host application.

Changed XPLAINBridge project to be both a USB to USART bridge and a PDI programmer, based on the state of a mode select pin.

Clean up and add more comments to the AVRISP-MKII project. Make sure the SPI_MULTI command handler supports multiple packet responses. Use slightly smaller/faster repeated indirect-load commands when retrieving the PDI target's memory CRCs.

Added support to the MIDI Class drivers for packed data, where multiple MIDI events are packed into a single USB packet. Added new MIDI Class driver flush routines to override packing behaviour.

Reduced guard bit time in the AVRISP project PDI/TPI protocols to reduce the time needed to reverse the data communication direction.

Fixed AVRISP PDI race condition where the guard time between direction changes could be interpreted as a start bit. Fixed TPI interface lines not being changed correctly when in bit-banged TPI mode.

Change the AVRISP project's RESET LINE makefile tokens to AUX LINE, as it is not always used for target reset.

Fix TPI NVM Write handler -- AVRStudio sends out writes in page sized chunks, not byte sized chunks.

Add first draft of the TPI NVM commands for reading, writing and erasing a target. Needs testing when physical access to a part is available.

Add dummy undocumented TPI XPROG parameters to the AVRISP project so that TPI programming mode can be entered.

Fix mistakes in the XPROGTarget.c/.h files for TPI mode software USART clock rate and PDI mode XPLAIN board autoconfiguration.