SDP Service improvements; fixed UUID for SDP service, added Service Discovery Server UUID, better documentation.

Oops - when adding a sequence header to the SDP response, the size value needs to be cleared, not the buffer pointer.

Service Discovery ServiceSearchAttribute requests require the response to be grouped by UUID, so the response can't be generated as the attributes are read in. Buffer both UUIDs and Attributes instead and generate the response afterwards.

Short UUIDs are measured in bytes, not bits -- update Service Discovery Protocol code so that it can now correctly match against UUIDs in the service table.

More SDP code improvements - responses to ServiceSearchAttribute service discovery requests should now be valid, even if they do not currently return the device's services and service attributes.

Added more documentation to the incomplete Bluetooth stack code.

Renamed CDC device class demos' ManagementEndpoint descriptor to NotificationEndpoint to more accurately indicate its purpose.

Switch over the BluetoothHost demo's Service Discovery code to pass around more generic GUID arrays.

Fixed AVRISP project not sending a full erase-and-write EEPROM command to XMEGA targets when writing to the EEPROM instead of the split write-only command (thanks to Tim Margush).

Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs after programming or reading from the last page of FLASH.

Remove incorrect check for the current device state in the Set Configuration request handler of DevChapter9, which broke Set Configuration requests to the device under most circumstances.

Move out the SPI prescaler list to a PROGMEM module-level variable in ISPTarget.c.

Fixed AVRISP-MKII clone project not correctly issuing SET EXTENDED ADDRESS commands when the extended address boundary is crossed during programming or readback (thanks to Gerard Sexton).

Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled.

Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly selected when the ISR completes.

The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver.

Fix Benito makefile which was accidentally changed during testing.

Fix nasty bug in USBInterrupt.c which would cause a lockup if the control endpoint was not selected at the point the USB endpoint interrupt fires when INTERRUPT_CONTROL_ENDPOINT is defined.

Refactor Service Discovery Protocol code in the incomplete Bluetooth Host demo, so that the UUID list is compiled via a seperate function to allow for its re-use between different SDP request types.

Add new ReportType parameter to the HID class driver device callback and host report sending routines.

Renamed internal Host mode Class driver descriptor comparator callback routines so that they all start with a uniform DCOMP_{Class Abbreviation}_ prefix.

Add svn:eol-style property to source files, so that the line endings are correctly converted to the target system's native end of line style.

Change over instances of "make" in the makefiles to "$(MAKE)" to allow for the make tool to be overridden.

Device mode class driver callbacks are now fired before the control request status stage is sent to prevent the host from timing out if another request is immediately fired and the device has a lengthy callback routine.

Inlined currently unused MIDI ProcessControlRequest routine.

Don't cast the line encoding baud rate to a uint16_t before performing the baud rate calculation in the Benito project.

Fix TeensyHID bootloader for the largest AVRs - only the ATMEGA128x needs the alternative addressing scheme.

Added new EVENT_CDC_Device_BreakSent() event and CDC_Host_SendBreak() function to the Device and Host CDC Class drivers.

Remove incorrect Abstract Call Management class specific descriptor from the CDC demos, bootloaders and projects.

Ensure that the CDC class drivers return 0 if the number of unread bytes is queried and the bank has become empty.

Make CDC class bootloader hard-reset the AVR when exited instead of a soft-reset. Reduce size of the TeensyHID bootloader slightly.

Fix the TeensyHID bootloader for the larger USB AVR devices, since Paul uses a different (undocumented) addressing scheme on these devices.

Fixed TeensyHID bootloader so that it works with the official TeensyLoader GUI application with all supported AVR models.

Removed software PDI/TPI emulation from the AVRISP-MKII clone project, as it was very buggy. PDI and TPI must now be implemented via seperate headers instead of the one unified ISP/TPI/PDI header.